Extended 1inch Rear & 6mm Front Race TVP Kit

The ideal upgrade for any serious racer who is all ways looking for the best possible performance.
Allays trying to save them extra few seconds from a race lap or fed up of getting beaten by that split second now is your chance to save some critical weight and earn back them few vital seconds.

These TVPs are specially design with racing in mind where lightens is a key aspect while also maintaining the utmost critical strength within the design.

These TVPs are extended 1inch at the back with 6mm front in length and use a 119mm dog bone. TVPS are made from 6082-T6 2.5mm thick.
TVPs are full Mid tank ready with pre-drilled holes for fixing of servos and tank, Full mid tank kit (see our midtank kit page)

Weight comparison table :-

Note: Weight- TVPs= weight of left & right TVP only, Weight complete= weight of TVP,Skid plate,engineplate & screws.
- weights above should be used as a guide line only.

Included Items :-
1x extended 1inch at the back with 6mm front LCG Race TVPs.
1x LCG Engine plate.
1x extended 1inch at the back with 6mm front  length skid plate.
1x TVP screw kit - Hardend grade 12.9 socket cap screws.

Detailed specification of parts:-
TVPs :-
These TVPs are lowered on the Engine and Gearbox giving the savage a more stable and lower ride height. These are made from 2.5mm thick 6082-T6 Aluminum.

12mm lowered on Engine & Gearbox.
Extra clearance for bigger flywheels.
Countersunk the two screw holes hidden by roll bar due to lowering, so no drilling or modding roll bar or TVPs after buying them also allows for mounting of any standard roll bar.

LCG Engine Plate for HPI Savage:-
This engine plate is designed to fit the LCG TVPs and is a must have item.
Made from one peace of 6082-T6 aluminum giving more strength than the standard Engine plate. This Engine plate also contains the needed cut-out for clearing the drive shaft and drive cup due to the lowering of the Engine and gearbox.
3mm Thick Engine plate (Overall with cross brace 9mm).
Cut outs to clear dog bone and drive cup.

Skid plate Specs :-
Skid Plate to fit to the LCG Race extended 1inch at the back with 6mm front TVPs.
Made from durable 2mm thick 6082-T6 aluminum.
The Screws are countersunk into the skid plate to offer screw clearance and smooth flush fixing to the bottom of the TVPs.

Roto Start:-
Please note, Roto unit will work with HPI quick access bulkheads found on savage X with no mods, when using standard hpi bulkheads please note ofna roto unit will need to be used or modding of the bulk head unit. after market bulks eg GPM work fine with out the cross brace and allow stock roto to be used.

Note: 6082-T6 gives upto 18% more strength than conventional 6061-T6